How to deal with the blockage of salt spray test machine pipeline?

If the salt spray test chamber pipes are clogged, follow these steps:

I. Determine the Blockage Location (Zhongzhi Times)

1. Observe the various pipes in the salt spray test chamber for obvious signs of blockage, such as salt crystal accumulation or foreign matter.
2. Inspect key areas, such as the brine pipes and spray pipes, to determine where the blockage may have occurred.

II. Clearing the Blockage

1. For Salt Crystal Blockages:

• Soak the pipes in warm water or a detergent of appropriate concentration to dissolve the salt crystals.
• Gently unclog the pipes with a soft brush or thin wire, but be careful not to damage the inner wall.

1. For Foreign Matter Blockages:

• Carefully disassemble the potentially clogged pipe section and remove the foreign matter.
• If the foreign matter is difficult to remove directly, use compressed air or a small vacuum cleaner to attempt to clear it.

III. Preventing Re-Blockages

1. Ensure that the brine used meets the test chamber requirements and is free of excessive impurities.
2. Perform regular maintenance on the salt spray test chamber, cleaning the pipes and nozzles.
3. After the test, drain the brine from the pipes promptly to prevent salt crystals from forming.

IV. Checking Equipment Operation (Dongguan Zhongzhi)

1. After clearing any blockages, restart the salt spray test chamber and check that the pipes are clear and the spray is flowing normally.
2. Observe the equipment for a period of time to ensure that no blockages occur again.